Thursday, September 28, 2006

"Should We Read Him His Rights?"


Poor old Alkali Jones. He should have known better than try to sneak that heifer past those two ranchers. At least one of them is having second thoughts about whether they should go ahead and string him up so maybe there's still some hope for him. Unfortunately, we'll never know.

This was a real fun scene to construct. I had carved the steer earlier for the Auctioneer scene in the previous post. However, once that scene came together it became apparent to me that the cow was too small next to the other figures. As I had already carved Alkali Jones I just added the Longhorn as evidence of the crime!

These figures are considerably smaller than those I normally carve. The Cowboy with the rifle stands about 8" tall and the overall height of the scene is about 18". While large it would still fit nicely on a desk corner or a sideboard.

The tree is a cedar branch I picked up at the National Pea Ridge Battlefield Park in Arkansas. My wife and I ride our horses over there and there are lots of dead cedar trees I use in scenes for fence posts, gates, etc. The branch that will soon support the weight of Alkali was added on and then modeled to match the larger trunk. The two vultures are held in place by metal rods which I epoxied to the branches. The Wanted sign is made out of metal. I guess poor old Alkali wasn't much of a rustler as, from it's absence on the poster, no reward was offered.

I spent an entire afternoon carving Alkali's gun and holster laying next to his hat. I had hoped to have some bullets on the belt but it just became too fragile to handle by the time I got to that step. The hat and six-shooter do a good job of filling up that empty spot.

So, the next time you're on your knees giving thanks for all your blessings, put in a word or two for Alkali. Maybe it's not too late for him to see the light and mend his ways.

3 comments:

  1. Lynn great job.

    I am a bit dumb.. I know you said 18 gauge galvanized wire to make rope but I cant find it anywhere in depot or lowes. I am not looking in the right place. Where in the store is it, i.e. electrical with wire, or hardware with the rope.

    Please help a dumb cowpoke.

    Thanks Brian

    ReplyDelete
  2. Brian I agree with you. Can't find it in southern Indiana at any Lowes or Home Depot. I did find 20 gauge and it seems to be ok.
    Lynn, This is another amazing project. Just unbelievable. Thanks so much for sharing the photos...Myron

    ReplyDelete
  3. Okay....I went to Lowes and here is the poop on the wire:

    The brandname is

    Hillman
    Multi-purpose Wire
    Galvanized Wire
    4-Strand, 20 Guage
    100 Feet....$4.37

    You'll find it in the Hardware section. To make the rope I pull off the length I need, remove one of the wires leaving the other three twisted. I chuck one end in the drill and the other in a vice, pull it tight and twist it till it looks good. MAKE SURE YOU DON"T ACCIDENTLY TWIST IT THE WRONG WAY AND UNCOIL IT! If you do you might get a 'bubble' along the length. You might have to run your drill in reverse. Hope this helps!!

    ReplyDelete